Installing PowerChute Network Shutdown v4 on Windows

After you finish the installation, you can use the Silent Installation to set up additional servers to have the same PowerChute Network Shutdown configuration.

In PCNS on these systems go to Configure Events and select UPS on Battery then Shutdown and set the shutdown delay to 10 or 15 minute. Because ...

Go to Configure Events. · Select UPS On Battery and click Shutdown. · Click Enable Shutdown. · Enter the desired amount of time you would like the ...

PowerChute Network Shutdown will always shut your servers down when low battery signal time is reached. It can be adjusted higher if you need more than two ...

Log into PowerChute web interface by entering the systems IP address or FQDN on port 6547. Examples https://192.168.1.10:6547 or https:// ...

To view the PowerChute Parameters on the Network Management Card (NMC), log into the card and go to Configuration and Shutdown; at the bottom ...

You must log on using the superuser account (apc) to add new users. 2. On the NMC user interface, go to the Configuration - Shutdown page. 3. Select the new ...

The ESX solution from APC is their virtual appliance. Install the appliance as a VM and sync it to the UPS. Then you can configure it to perform ...

15:22 Go to channel Configuring PowerChute Network Shutdown for VMware ESXi & vCenter | Schneider Electric Support

APC PowerChute Network Shutdown works in conjunction with the UPS Network Management Card(NMC) to protect your physical and virtual IT ...